Eau Claire, WI · Trusted Home Improvement Since 1993
Siding installation and replacement in Chippewa Falls, WI. Vinyl and fiber cement sized for freeze-thaw and wind exposure. Local since 1993. Call (715) 894-1120.
BBB Accredited · Licensed & Insured · Free Estimates
Or call directly: (715) 894-1120
Midwest Home Improvements
If your siding is cracking, warping, or letting moisture behind it, siding installation in Chippewa Falls, WI starts with why the old cladding failed here, not just hanging new panels over the same problem. Midwest Home Improvements installs and replaces siding across Chippewa Falls, and after 33 years on these walls we've learned the failures in this town cluster on the north and west elevations that take wind off open ground, and on older homes where water got behind the panel and froze. We pull the old material, check the sheathing and house wrap for rot before anything new goes up, and match the siding to your home's actual exposure instead of selling one product to every house. Owner Stephen Bonander founded the company in 1993, and it stays licensed, insured, and BBB accredited. Call (715) 894-1120 to set up a free on-site walkthrough.
Most Chippewa Falls homeowners searching for siding fall into one of two spots: a full replacement of cladding that's failed, or first new siding as part of a bigger exterior project. This page covers both, and it's specific to Chippewa Falls because the housing here behaves differently than a subdivision two towns over. The 1880s to 1920s two-stories in the historic district around Bridge Street and Duncan Creek were often sided over old wood lap, and the lots out toward Lake Wissota and along the Highway 124 corridor sit in open wind that punishes brittle panels. For the broader picture on materials and cost, our siding installation and replacement page covers it. This page is about your house, in this climate, on this river corridor.
Free, no-pressure estimates — talk to a real person today.
Siding installation in Chippewa Falls, WI runs a few days to a week for a typical home once material is on-site, and it starts behind the old panels, not in front of them. We pull the existing cladding, then inspect the sheathing and house wrap for the rot and moisture damage that a fresh panel would just cover up for a season or two. On the pre-1940 homes around Bridge Street we find soft sheathing under the old siding more often than not, usually where a failed gutter or a bad flashing detail sent water into the wall for years.
Once the wall is sound we install a proper moisture barrier, then run the new siding from the bottom up with the overlap and fastening pattern the material calls for. The part that separates a job that lasts from one that fails in five years is the transitions: where siding meets the windows, the roofline, and the trim. Those are the exact spots a Chippewa Valley winter drives water and ice, and they get flashed as one continuous detail, not lapped over and hoped for. Ready when you are, call (715) 894-1120.
Home siding replacement in Chippewa Falls, WI is the right call when the cladding is cracked or brittle, when panels are pulling loose from the wall, or when you can see moisture damage, chalking, or paint failure that no repair will hold. Covering failing siding with a repair patch on one elevation while the rest keeps degrading just resets the clock a year. We tell you honestly whether you're looking at a repair or a full replacement after we get a hand on the walls.
"The brittle cracking we get called about is almost always on the north and west walls, the ones taking wind off open farmland toward Elk Mound and out past Lake Wissota. Cheap vinyl goes hard in a Chippewa Valley cold snap, and the next windblown branch or ladder bump splits it. That's the elevation we design the material choice around."
Here's when replacement makes sense versus when a repair does the job:
We'll walk your elevations and tell you which one your house needs before quoting. Get a free quote and we'll look at the walls before giving you a number.
Durable, low-maintenance, and the most budget-friendly option for most Chippewa Falls homes. We steer you toward a mid-grade or better panel rather than the cheapest stock, because the bargain vinyl is exactly what goes brittle on the north and west walls here.
Fiber cement, and the James Hardie line homeowners ask us about by name, stays dimensionally stable through the freeze-thaw swings and won't go brittle in a cold snap. It's the material we recommend most on exposed elevations. See our approach on the siding services page.
Engineered wood like LP SmartSide resists impact better than standard vinyl and holds paint far longer than real wood. A solid middle option for homeowners who want the look of wood without the maintenance cycle.
Full tear-off of failed wood lap or first-generation vinyl, with a sheathing and house-wrap rot check first. On the older historic-district homes, the rot behind the siding is often the real repair the last crew skipped.
Siding, windows, and gutters as one exterior job instead of three separate crews. We flash the window-to-wall and roof-to-wall transitions as a continuous detail, which is where water gets in when trades work apart. See siding and gutters as one exterior job in Chippewa Falls.
New cladding as part of a larger renovation, matched to the existing house so an addition or remodel doesn't look bolted on. Ties into new siding for your Chippewa Falls home when the project goes beyond the walls.
The fiber cement versus vinyl siding question in Wisconsin comes down to how each material behaves when a Chippewa Valley winter swings from a 20-below January morning to a thaw by afternoon. The honest short version: vinyl is the better spend on a rental or a home you'll sell inside a few years, and fiber cement usually wins the math if you're staying put for the long haul on an exposed lot. Neither is the right answer for every house, and any contractor who leads with one product before looking at your walls is selling, not advising.
Color retention is the other Wisconsin-specific difference, and it cuts against our climate hard. James Hardie's factory-applied finish is cured onto the board rather than field-painted, so it resists the UV fade of long July afternoons and the constant wet-dry-freeze of the shoulder seasons. It also carries a Class A fire rating that vinyl can't match. What you pay for that is a higher up-front cost, because the board is heavier, has to be cut with dust control, and demands precise fastening and flashing to perform. If you plan to be in the home a long time, that premium usually pays back. Not sure which side of that line your house is on? Call (715) 894-1120 and we'll walk your elevations with you before you spend a dime.
Here's the honest part most siding companies won't put on their own site: not every Chippewa Falls siding problem is a full replacement, and you shouldn't pay for one you don't need. If your siding is current-grade and sound, and the only issue is one section that took a hit from a branch, a ladder, or a stray baseball, that's a repair, not a tear-off.
Where a full replacement earns its keep is the problem a patch won't fix: brittle cracking across an elevation, moisture already behind the wall, or failed cladding at the end of its service life. Those compound every winter in this climate, and the longer they run the deeper into the sheathing the damage goes. Straight talk before you spend is the difference between a contractor and a sales pitch.
Reviews
We've installed and replaced siding across Chippewa Falls and the Chippewa Valley since 1993. A few words from homeowners here.
The old vinyl on the north side of our house had cracked to pieces over a couple of hard winters. Midwest Home Improvements found soft sheathing underneath, replaced it, and put up fiber cement on the exposed walls. They were the only ones who checked behind the panels before quoting.
House is from the 1910s and we did siding and windows at the same time. Having one crew flash the transitions meant no leaks at the corners where the old work always let water in. Same faces start to finish, no subcontractor churn.
Fair price and honest advice. They told us straight that mid-grade vinyl was the right spend for us instead of pushing the most expensive product. Showed up when they said and cleaned up after themselves.
Good to Know
Whether you need a full siding replacement or new cladding as part of a larger exterior project on your Chippewa Falls home, we'll walk your elevations, check what's behind the old panels, and give you a straight estimate before anything starts. Our siding work connects to the rest of the exterior we handle, including siding installation in Chippewa Falls, new and replacement gutters for Chippewa Falls homes, and new siding for your Chippewa Falls home as part of a remodel. Call (715) 894-1120 or send us the details and we'll get back within one business day. Honest. Professional. Local since 1993.
Request a free estimate
Tell us about your project — we'll be in touch within one business day.
Good to Know
